Adam Equipment gbc-gfc series Manuale Utente
P a g e
29
© Adam Equipment Company 2011
12.1.1
F1 -CALIBRATION
To enter the calibration parameter, press the [Tare] key when “F1” “CAL” is displayed.
The scale should be calibrated using a mass of approximately 2/3Maximum to
Maximum. If the scale has been calibrated previously the value will be stored.
Details of calibration are given is section 8.0 .
The scale should be calibrated using a mass of approximately 2/3Maximum to
Maximum. If the scale has been calibrated previously the value will be stored.
Details of calibration are given is section 8.0 .
12.1.2
F2 –PIN
•
To enter this parameter, press the [Tare] key when “F2” “Pin” is shown.
•
The “Weight” display will show “Pin 1”
•
Enter the new password. The “Unit Weight” display will show dashes.
Press [Tare].
Press [Tare].
•
The “Weight” display will change to “Pin 2 “, Enter the password again
and press [Tare].
and press [Tare].
•
The display will show “donE” indicating the new password has been
accepted and will return to the menu. “F3” “Unit” is shown.
accepted and will return to the menu. “F3” “Unit” is shown.
•
Record the new password in a secured place.
•
Press [Zero] to return to weighing.
12.1.3
F3 –Unit
•
To enter this parameter, press the [Tare] key when “F3” “unit” is
shown.
shown.
•
This parameter allows the user to enable or disable the weighing units
available in his scales.
available in his scales.
•
To enter this parameter, press the [Tare] key when “F3” “Unit” is
shown.
shown.
•
The display will show the first available weighing unit and if it is On or
Off.
Off.
•
Press the [U.Wt./Units] key to change the value. Press [Tare] to
accept the displayed setting and go to the next unit.
accept the displayed setting and go to the next unit.
•
Press the [Zero] key to return to the menus. Press the [Zero] key again
to return to normal weighing.
to return to normal weighing.