Adam Equipment gbc-gfc series Manuale Utente
P a g e
7
© Adam Equipment Company 2011
3.3
SETTING
UP
THE
SCALES
•
The pillar is attached to the base using a bracket that must be attached
to the base frame first using the 4 bolts supplied. The pillar is secured
to the bracket using 2 sets of screws. The cable from the base to the
indicator module is run through the tube and taken out through the
plastic support at the top. Excess cable can be stored within the tube.
to the base frame first using the 4 bolts supplied. The pillar is secured
to the bracket using 2 sets of screws. The cable from the base to the
indicator module is run through the tube and taken out through the
plastic support at the top. Excess cable can be stored within the tube.
•
The GBC/GFC Series comes with a stainless steel platform packed
separately. Place the platform in the base.
separately. Place the platform in the base.
•
Level the scale by adjusting the four feet. If the scale rocks re-adjust the
feet.
feet.
•
Attach the indicator module to the pillar by sliding it over the bracket
with the flanges engaged in the groves on the base. Attach the cable
from the base to the connector on the rear of the indicator.
with the flanges engaged in the groves on the base. Attach the cable
from the base to the connector on the rear of the indicator.
•
Attach the power to the indicator. Press the [On/Off] key which is at
the rear of the indicator. The software revision number will be
displayed followed by a self-test showing all digits before the zero is
displayed along with the unit of weight that was selected last.
the rear of the indicator. The software revision number will be
displayed followed by a self-test showing all digits before the zero is
displayed along with the unit of weight that was selected last.