Epson EPL-N1200 Manuale Utente

Before you print with a serial interface, you must match the
serial settings used by the printer and your computer. You can
change the default settings (listed in the table below) for the
serial interface card or the LocalTalk/Serial module, or you can
change your computer’s serial port settings; see your computer
manual for instructions.

Optional serial interface default settings

Serial type

RS-232C

Word length

8

Baud rate

9600

Parity

None

Stop bit

1

DTR

Off

XON/XOFF

On

You also need to set Windows to use a serial port with your
printer, as described in the next sections.   

Note:
You can change your printer’s serial interface setting using SelecType
(see Chapter 3) or by running the Remote Control Panel utility (see
the Technical Information manual. You can also match the printer’s
and computer’s baud rate or to set the printer to a higher baud rate
than that supported by your computer (this may not work with some
computer systems). See the Technical Information manual for more
information.