Edelbrock 5280 Manuale Utente

 

•     

INSTALLATION: 

 

1.

Place vehicle on level, stable ground (i.e. concrete driveway). 

 
2.

Raise vehicle and support under the frame so  rear end can be raised and lowered if needed.  
Removing rear wheels is not required, but can be helpful.  

 
3.

Unbolt front bushing bracket from transmission. 

 
4.

Unbolt rear of torque arm from rear end.  To remove bolts, it may be necessary to raise or lower 
rear end.  Remove torque arm from chassis. 

 
5.     Remove front bushing and bushing bracket from O.E.M. arm. 

 

Please read and study these instructions before installing your new torque arm.  If you have any questions, 
please contact us at our Technical Hotline: 1-800-416-8628, 7:00 am – 5 pm, Monday through Friday, Pacific 
Standard Time. 

•     

NOTE:    

This torque arm is designed to fit 
1984-2000 Camaro/Firebird with 
front torque arm locator lips  
facing away from driveshaft.  See 
Figure 1. 

•

PREPARATION CHECKLIST:  The following equipment is required: 

ü Jack 
ü Jack stands (4 required)  
ü Drill with 7/32 drill bit or grinder to remove rivets 
ü 13mm, 15mm, 21mm Socket and wrenches 
ü Torque wrench 
ü Thread lock compound 

•     

CAUTION:   

Installation requires being under 

raised vehicle.  Support vehicle 
on level and stable ground, using 
proper load rated jack stands. 

Lip 

Correct 

Incorrect 

Lip 

Lips Facing Away 
From Driveshaft 

Lips Facing  

Towards Driveshaft