Trimble Outdoors r7 Manuale Utente

1 5       Configuration

1 3 6      Trimble R7/R8 GPS Receiver User Guide

apply an application file that only specifies the elevation mask to use, 
all other settings remain as they were before the application file was 
applied.

You can store up to twenty different application files in the receiver. 
You can apply an application file’s settings at the time it is transferred 
to the receiver, or at any time afterwards.

The Trimble R8 receiver has three special application files, which 
control important aspects of the receiver’s configuration.

The default application file (Default.cfg) contains the original receiver 
configuration, and cannot be changed. This file configures the receiver 
after it is reset. You can reset the receiver by holding down 

p for at 

least 15 seconds, or by using the reset option in GPS Configurator.

For more information on the default receiver settings, see Default 
Settings, page 159.

Although you cannot change or delete the default application file, you 
can use a power up application file to override any or all of the default 
settings.

The current application file (Current.cfg) reflects the current receiver 
configuration. Whenever you change the receiver’s configuration, 
either in real time or by applying an application file, the current file 
changes to match the new configuration.

You cannot delete the current file or change it directly, but every 
change to the receiver’s current configuration is applied to the current 
file as well.