Samson PBPRO7 Manuale Utente
8
Guided Tour -
PowerBrite PB9 Rear Panel
PowerBrite PB9 Rear Panel
1: Switched AC outlets (horizontal mount) - Connect external
equipment to these standard 3-pin AC outlets, which are turned on and
off from the front panel Outlets switch (see #2 on the previous page).
equipment to these standard 3-pin AC outlets, which are turned on and
off from the front panel Outlets switch (see #2 on the previous page).
2: Switched AC outlets (vertical mount) - Similar to the AC outlets
described in #1 above, these are mounted vertically so as to
accommodate external transformer AC power adapters.
described in #1 above, these are mounted vertically so as to
accommodate external transformer AC power adapters.
3: Fluorescent starter - This is a standard 4 watt, 110 volt condenser
type fluorescent starter, used for starting the fluorescent light in the
slide-out drawer (see #3 on the previous page). To remove the starter,
twist it counterclockwise a half-turn and pull it straight out. To insert a
new starter, line up its pins with the slot and twist it a half-turn in the
other direction. Be certain the replacement starter is rated at 4 watts or
greater.
type fluorescent starter, used for starting the fluorescent light in the
slide-out drawer (see #3 on the previous page). To remove the starter,
twist it counterclockwise a half-turn and pull it straight out. To insert a
new starter, line up its pins with the slot and twist it a half-turn in the
other direction. Be certain the replacement starter is rated at 4 watts or
greater.
SWITCHED
SWITCHED
MAXIMUM 15 AMPERE LOAD FOR ALL 9 OUTLETS
SAMSON
or
F
L
U
O
R
E
S C
E N T S
TA
R
T
E
R
•
1
1
0/
22
0V
4W
A
T
T
S
•
1
3
2
10A
MAX. LOAD
F
L
U
O
R
E
S C
E N T S T
A
R
T
E
R
•
C
O
N
D
EN
SE
R
4
W
A
T
T
S
•