Sanyo clt-a5832 Manuale Utente

24

A long warbling tone

Signals an incoming call

Single Tone

A key is pressed

Three short beeps

Error tone

Two long beeps

Confirmation tone

One short beep and one long beep

Page signal

Three beeps every 2 seconds

Transfer signal

Two short beeps every 15 seconds

Low battery warning

No display

• Is battery fully charged?  Try replacing the battery.
• Make sure that the base is connected to a non-switched AC outlet.

Disconnect the base from the plug and plug it in again.

• Did you order Caller ID service from your local telephone company?

The display will not work unless you do this.

Caller ID error message

• The phone displays this message if it detects anything other than valid

Caller ID information during the silent period after the first ring.  This
message indicates either the presence of noise on the line, or that an
invalid message has been sent from the telephone company.

The Handset does not display the Caller ID information

• Check with your local telephone company to ensure that the Caller ID or Call

Waiting Caller ID service is subscribed to and is functioning properly.

• If you answer the call before the first ring has been completed, the Caller ID

information may have not been completely received by your phone.

• If you are using the additional handset(s) CLT-A5822 and CLT-A5832, try re-

registering it to the main base as described in the manual.

Telephone Numbers are not being correctly dialed from the Caller ID memory

• Ensure that the number displayed is in the correct format and that if the area

code and/or a "1" are included in the dialing process.

sy5822 10 april.p65

2006/5/12, ¤U¤È 02:52

24