Agilent Technologies 664xA Manuale Utente

 
 This command selects the trigger source.  Since the power supply has no other trigger source than the GPIB bus, this
command need not be used.  It is included in the command set to provide programming compatibility with other instruments
(such as the Agilent Electronic Load family) that may have more than one trigger source.
 
 

 

 

 

 

 

 

 

 
 This subsystem programs the output voltage of the power supply.

 
 These commands set the immediate voltage level or the pending triggered voltage level of the power supply.  The immediate
level is the voltage programmed for the output terminals.  The pending triggered level is a stored voltage value that is
transferred to the output terminals when a trigger occurs.  A pending triggered level is unaffected by subsequent VOLT
commands and remains in effect until the trigger subsystem receives a trigger or an ABORt command is given.  If there is
no pending VOLT:TRIG level, then the query form returns the VOLT level.  In order for VOLT:TRIG to be executed,
the trigger subsystem must be initiated (see INITiate).
 
 

Command Syntax 

 

Table 3-1

 

 

Table 3-1

 

VOLT 200 MV        VOLTAGE:LEVEL 200 MV

 

 

VOLT:TRIG 20        VOLTAGE:LEVEL:TRIGGERED 20

 

 

<NR3> VOLT? and VOLT:TRIG? return presently programmed 
immediate and triggered levels.  If not triggered level is programmed, 
both returned values are the same.

 

VOLT?  MAX and VOLT?  MIN return the maximum and 
minimum programmable immediate voltage levels.

 

VOLT:TRIG?  MAX and VOLT:TRIG? MIN return the 
maximum and minimum programmable triggered voltage levels.

 

For VOLT     *SAV     *RCL      *RST

 

For VOLT:TRIG       ABOR     VOLT     *RST