Auto Page autopage rs-850lcd Manuale Utente

                                                                                  

JAN/07/2003 

 

RS850 OP   

11

  

When armed, your vehicle is protected as follows: 

1. Light impact will trigger the warn-away signal.   
2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the 

ignition key will trigger the programmed sequence. 

The starter disable relay (if installed) prevents the vehicle’s starter from 
cranking. The siren, horn, parking lights, and dome light will turn on to 
alerting of an i ntrusion for 60 seconds. Then it will stop and automatic reset 
and re-arm. If the one of sensors or detectors still active, the alarm system 
will sound a maximum of 3 times of 60 seconds cycles.

 

CLEAR THE FLASH ICON AND MELODY SOUND:  While 
triggering the alarm the LCD screen will alert user through 

melody sound and flashing trigger icon, press the 

 

button 3 times within 3 seconds will clear the flash icon 
and stop melody sound on the LCD screen transmitter. 
STOP THE MELODY SOUND ONLY:  While triggering the 
alarm the LCD screen will alert user through melody 
sound and flashing trigger icon, press any button on the 
LCD remote transmitter to stop melody sound only

NOISE ABATEMENT CIRCUIT:  You system has “Noise Abatement Circuit”. It 
prevents annoying repetitive trigger sequences due to faulty door pin 
switches or environmental condition such as thunder, jackhammers airport 
noise, etc. 
Here’s how “Nois e Abatement Circuit” works: The alarm triggers five times. 
Each time, the same sensor or switch is triggering the alarm. “Noise 
Abatement Circuit” will interpret this pattern of triggers as false alarm. After 
the fifth trigger, “Noise Abatement Circuit” ignores, or bypasses, that sensor 
or switch until the other sensor or switch is trigger. 
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm 
is triggered by an open door for three full cycles, the doors will be bypassed 
until the trigger ceases.