Acu-Rite 832 Manuale Utente

Pagina di 4
RE-SYNC
ºC/ºF
MIN
MAX
2 • SE TUP
A. Wireless Sensor
Remove the battery 
compartment cover and 
install 2  fresh “AA” batteries 
as shown here.        
Always 
install batteries into the 
wireless sensor FIRST to 
ensure proper wireless 
synchronization with the 
main unit.
B. Main Unit 
Remove the battery 
compartment cover and 
install 2 fresh “AA” batteries 
as shown here. 
Install Batteries
The wireless sensor will soon send a signal to the main unit and the two units will 
be synchronized. The wireless sensor features a red light on the front which will 
illuminate briefly once a minute to indicate it is sending a signal. It may take a 
few minutes for synchronization to be complete. If both or one of the units 
appear to be functioning improperly, refer to the troubleshooting section in this 
manual.
Basic Setup is Now Complete
NOTE: Install all batteries in both units 
within a 6 minute period to ensure 
proper wireless functionality.
- 3 -
- 2 -
INSTALL
2 “AA”
BATTERIES
REMOVE
BATTERY
COMPARTMENT
COVER
Place the main unit in a dry area free of dirt and dust. To help ensure an 
accurate indoor temperature measurement, be sure to place the main 
unit out of direct sunlight, and away from any heat sources or vents in 
your home.
There are 2 placement options for the main unit. You may hang the main 
unit on a wall using the integrated hang hole. Alternatively, you may 
place the main unit on a table top or other flat surface.
Placement of Main Unit
The wireless sensor MUST BE PLACED OUTDOORS to observe outdoor 
temperatures and relay the outdoor temperature to the main unit display. 
The wireless sensor must be placed less than 100 feet from the main unit. 
The wireless sensor is water resistant and is designed for outdoor use. 
However, to extend the life of the product, place the wireless sensor in an 
area protected from direct weather elements. To ensure an accurate 
outdoor temperature measurement, be sure the wireless sensor is placed 
out of direct sunlight and away from any heat sources.
Placement of Sensor
3 • PLACEMENT
Now that setup is complete, you must choose a location to place the wireless sensor 
and the main unit. The wireless sensor MUST be placed less than 100 feet away from 
the main unit.
This wireless thermometer uses radio frequency for communication, which is 
susceptible to interference from other electronic devices and large metallic items or 
thick walls. Always place both units at least 3 feet away from appliances ( TV, 
microwave, radios, etc. )  or objects ( large metal surfaces, thick stone walls, etc. ) that 
may interfere with the wireless communication.
TV
3
REMOVE
BATTERY
COMPARTMENT
COVER
ºC/ºF
ARTMENT
N
Extended periods of cold temperatures ( below -4ºF / -20ºC ) can cause 
alkaline batteries to function improperly. This will cause the outdoor 
wireless sensor to stop transmitting temperature readings. Use lithium 
batteries in these low temperature conditions to ensure continued 
operation for wireless sensors placed outdoors.
40