American Standard deck mount bath filler 2064.90x Manuale Utente

5/16'' MIN.

MOUNTING
SURFACE

Push TUBING (3) ends into VALVE (4) side outlets. Insert VALVES (4)

into mounting holes from underside of ledge.
Press TEE (5) onto SPOUT SHANK (6) making certain that the O-RING (7) is

properly seated on SHANK (6). Push COUPLING (8) into TEE (5) and attach to
SPOUT SHANK (6) and tighten using a 10mm (3/8'') hex wrench. Tighten

COUPLING (8) using a 10mm (3/8") Hex wrench. (FOR 2064.901). Use

COUPLING (8a) for fitting less spray. 

Install LOCKNUTS (1) and RUBBER WASHERS (2) onto valve shanks.

Place RUBBER RING (10) into ESCUTCHEON ADAPTERS (9) and thread onto

valves until snug against internal stop.
Tighten LOCKNUT (1) with WRENCH supplied to secure VALVE (4) position.

Slide FERRULE (12) and COUPLING NUT (13) to outlet of VALVE (4) and tighten

COUPLING NUT (13) firmly.

Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of

right VALVE using appropriate connector.

MOUNTING

SURFACE

Thread of VALVE BODY (4) should extend at least 5/16 inch above MOUNTING

SURFACE (11). If necessary, adjust LOCKNUT (1).

M 9 6 8 8 3 0   R e v . 1 . 4

Wrench

To change direction of handle rotation, 

proceed as follows:

Turn valve to OFF position.
Thread counter-clock wise HANDLE BASE (1) to remove
HANDLE ASSEMBLY (2) from ESCUTCHEON BASE (3).
Use a flat blade screw driver to remove SPRING CLIP (4).
Lift STOP WASHER (5), turn 90˚  and replace.
Replace SPRING CLIP (4).
Reinstall HANDLE ASSEMBLY (2)

.

If spout drips, operate handles several times from OFF to ON

position. Do not force - handles turn only 90˚.

Push ADAPTER (1) on VALVE STEM (2). See figure "A". Tighten
STEM SCREW (3) to secure ADAPTER (1). 

Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting
male teeth on ADAPTER (1) to female teeth in HANDLE (4).

Thread LEVER HANDLE ASSEMBLY (4) onto DECK ADAPTER (5)
until snug against mounting surface

.