Pioneer cdj-900nexus Manuale Utente

Operating environment temperature and humidity:
+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH 
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in 
locations exposed to high humidity or direct sunlight (or 
strong artificial light).

The 

  switch on this unit will not completely shut off 

all power from the AC outlet. Since the power cord 
serves as the main disconnect device for the unit, 
you will need to unplug it from the AC outlet to shut 
down all power. Therefore, make sure the unit has 
been installed so that the power cord can be easily 
unplugged from the AC outlet in case of an accident. 
To avoid fire hazard, the power cord should also be 
unplugged from the AC outlet when left unused for a 
long period of time (for example, when on vacation).

When using this product, confirm the safety 
information shown on the bottom of the unit.

This product satisfies FCC regulations when shielded 
cables and connectors are used to connect the unit 
to other equipment. To prevent electromagnetic 
interference with electric appliances such as radios 
and televisions, use shielded cables and connectors 
for connections.

Water droplets (condensation) may form inside the unit 
(on operating parts and lenses) in the winter, for 
example, if the unit is moved from a cold place into a 
warm room or if the temperature in the room in which 
the unit is installed rises suddenly (through heating, 
etc.). The unit will not operate properly and will not be 
playable with condensation inside. Let the unit stand for 
1 to 2 hours at room temperature (though this time 
depends on the conditions of the condensation) without 
turning on the power. The water droplets will evaporate 
and the unit will become playable. Condensation can 
occur in the summer as well if the unit is exposed to the 
direct wind from an air-conditioner, etc. If this happens, 
move the unit to a different location.

Handle the power cord by the plug. Do not pull out the 
plug by tugging the cord and never touch the power 
cord when your hands are wet as this could cause a 
short circuit or electric shock. Do not place the unit, a 
piece of furniture, etc., on the power cord, or pinch the 
cord. Never make a knot in the cord or tie it with other 
cords. The power cords should be routed such that they 
are not likely to be stepped on. A damaged power cord 
can cause a fire or give you an electrical shock. Check 
the power cord once in a while. When you find it 
damaged, ask your nearest PIONEER authorized 
service center or your dealer for a replacement.

This equipment is not waterproof. To prevent a fire or 
shock hazard, do not place any container filled with 
liquid near this equipment (such as a vase or flower 
pot) or expose it to dripping, splashing, rain or 
moisture.

To prevent a fire hazard, do not place any naked flame 
sources (such as a lighted candle) on the equipment.

When installing this unit, make sure to leave space 
around the unit for ventilation to improve heat radiation 
(at least 5 cm at rear, and 5 cm at each side).

Slots and openings in the cabinet are provided for 
ventilation to ensure reliable operation of the product, 
and to protect it from overheating. To prevent fire 
hazard, the openings should never be blocked or 
covered with items (such as newspapers, table-cloths, 
curtains) or by operating the equipment on thick carpet 
or a bed.