Autostart as-6205 sh Manuale Utente

P.20 Installation 

Guide

 AS-6205 SH 

x Doors locked, Starter Kill armed. 
x End of Run Time. 
x

 button pressed 

x

 signal received by the Module. 

x Cold Weather Mode cancelled. 
x Cannot start after maximum number of attempts is reached. 

x Run Time cancelled. 
x Remote start attempt cancelled by remote. 
x Doors unlocked, Starter Kill disarmed. 

x Entering Cold Weather Mode 

x +12 volts detected on the Brake line; cranking cancelled 
x Entering Tach Learning 

x New Transmitter learnt  
x Tach learnt 

x Remote start attempt was made with a Tach or a vacuum signal detected before 

cranking

x Unit reset: occurs when the unit is reset to factory defaults 

x The Hood Switch line went to ground during cranking or run time 

x There was an attempt to start the vehicle while the Module was in Valet Mode. 

x There was an attempt to start the vehicle while the Module was in Home Valet 

Mode. 

x Cold Weather Mode: the Brake Pedal is being held down 

x The Hood is up and the Hood Switch line went to ground. This is step one of the 

Programming Mode 

x First press of the 

button under Safe Start. 

x Entering Home Valet Mode 

x

or

pulse (if door pulse is configured to 4 sec.) 

x If the Hood Pin-switch has been pressed twice: the Unit went into step 1 of the 

Programming cycle and no Transmitter activity was detected for 20 seconds 

x Or the Unit went into step 1 of the Transmitter Code Learning procedure and no 

activity was detected for a few seconds. The Unit has exited the Transmitter Code 
Learning procedure. 

x If the Module gives irregular flashes (1 to 10 flashes followed by a pause, followed 

by more flashes), it is in Playback Mode. This occurs when the Hood-switch line is 
flashed 3 times. 

x Panic Mode set off.