Adam Equipment 302666242 Manuale Utente
© Adam Equipment Company 2011
Page
13
6.1 ZEROING AND TARING THE DISPLAY
The Tare and Zero function are combined into one key. When the
gross weight is within ±2% of the zero, set at power on for either scale
then a new zero is set. If the gross weight is greater than ±2% then the
tare function is performed.
gross weight is within ±2% of the zero, set at power on for either scale
then a new zero is set. If the gross weight is greater than ±2% then the
tare function is performed.
ZEROING
•
You can press the [Tare/Zero] key at any time to set the zero
point from which all other weighing and counting is measured.
When the zero point is obtained the Weight display will show the
indicator at “Zero”.
point from which all other weighing and counting is measured.
When the zero point is obtained the Weight display will show the
indicator at “Zero”.
•
The scale has an automatic re-zeroing function to account for
minor drifting or accumulation of material on the platform.
However you may need to press the [Tare/Zero] to re-zero the
scale if small amounts of weight are still shown even when the
platform is empty.
minor drifting or accumulation of material on the platform.
However you may need to press the [Tare/Zero] to re-zero the
scale if small amounts of weight are still shown even when the
platform is empty.
TARING
Preset tare values can be used with both the local and remote scale. If a new
tare value is to be used, there are two methods for entering a tare value. The
first method uses the weight on the platform and the second uses a value to
be entered by the user.
First method of entering a tare value:
•
Zero the scale by pressing the [Tare/Zero] key, if necessary. The arrow
indicator over “Zero” will be on.
•
Place a container on the platform, a value for its weight will be
displayed.
•
Press the [Tare/Zero] key to tare the scale. The weight that was
displayed is stored as the tare value and that value is subtracted from
the display, leaving zero on the display. The arrow over "Net" will be
on. As product is added only the net weight of the product will be
shown. The scale could be tared a second time if another type of
product was to be added to the first one. Again only the weight that is
added after taring will be displayed.
the display, leaving zero on the display. The arrow over "Net" will be
on. As product is added only the net weight of the product will be
shown. The scale could be tared a second time if another type of
product was to be added to the first one. Again only the weight that is
added after taring will be displayed.