Ariens 924121 1128 Manuale Utente

 

GB - 12

 

• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2, 9/16" 

and/or Adjustable Wrench

• Tire Gauge

 

1. Remove lower wing knobs on handlebar 

assembly (Figure 5).

2. Remove upper wing nut and bolt on shift 

rod.

3. Loosen upper wing knobs on handlebar.
4. Loosen lower wing nut and bolt on shift 

rod.

5. Put speed selector lever into fastest 

reverse panel notch.

6. Rotate handlebar up so wing knob holes 

align. Install and tighten all wing knobs.

7. Install wing nut and bolt removed in step 2 

onto shift rod and tighten hardware.

 

1. Grease discharge chute ring on blower 

housing (if not already greased).

2. Remove mounting hardware from top of 

engine.

3. Slide chute ring under retainer clip on 

blower housing and put chute on housing.

4. Secure chute by fastening chute strap to 

engine with hardware just removed.

 

 Washers and lock nuts go on top of 

chute strap.

5. Loosen mounting nut on chute and move 

chute up or down so that chute ring is 
approximately centered between retainer 
clip and lower ring and tighten.

6. Slide chute crank rod through bracket 

under handlebar and through hole in 
panel.

7. Align chute crank rod with the universal 

joint on chute and fasten with spring clip.

 

AVOID INJURY. Read 

and understand the entire 

 

 

section before proceeding.

 

Dropping or tipping over 

boxed unit could result in personal 
injury or damage to unit.

Figure 4

Chute Crank (924121,122, 

118, 332, 508, 551)

Discharge 
Chute

Sno-Thro 
Unit

OS1642

1. Handlebar 

Assembly

2. Wing Knobs
3. Wing Nut

4. Speed Selector
5. Bolt
6. Shift Rod

1

2

4

5

6

Figure 5 

3

OS0901

2