ATTO Technology 2400c-r-d Manuale Utente

•  Flow Control: None
•  Terminal type: ASCII
•  Echo: on

f. Click

OK.

After you connect to the Fibre Bridge, start-up
messages are displayed. These messages are
only displayed at start-up. The last line in the
start-up message sequence is

Ready.

In serial port sessions, there is no prompt on
the line below the word

Ready. Begin typing

commands in the blank line where the cursor is

resting. No user name or password is required
for serial port access.

To verify that you have connected successfully,
type

help after the Ready prompt and press

Enter.
• If a list of all available commands does not

appear on the screen, review the steps in this
section, check the cable, or contact service
personnel until the problem is solved.

If you have difficulty using the serial port, verify that
you have the correct settings and that your serial cable
is less then two meters in length.

Using Telnet

Up to three Telnet sessions can be conducted
simultaneously. A serial port session can use the CLI
while Telnet sessions are open. Whichever session
issues the first set CLI command can continue to issue
set commands, while the other sessions can only issue
get commands or display information. Once a
connection is established, refer to

CLI provides

ASCII-based interface

on page ii of the Appendix.

Connect to the Fibre Bridge from a computer on
the same Ethernet network.

Start a Telnet session.

Note

There is more than one way to connect to the
Fibre Bridge using a telnet program.Your

telnet program may operate differently than in
the following instructions.

At the telnet prompt, issue the

open command

where x.x.x.x is the IP address of the Fibre
Bridge.

telnet > open x.x.x.x