Pioneer pdp-425cmx Manuale Utente
3
RS-232C Adjustment
1.2 Interface
1) Connector
D-sub 9 pins (male/straight)
2) Pin layout
3) Baud Rate
9600 bps (standard)
(switch-able to 1200, 2400, 4800, 19200, 38400 bps)
(switch-able to 1200, 2400, 4800, 19200, 38400 bps)
Note
The baud rate of this display should be set to match the baud rate of the PC.
Also, when the RS-232C cable is extended over a long distance, use a slower baud rate.
Also, when the RS-232C cable is extended over a long distance, use a slower baud rate.
4) Data format
Start bit: 1 bit
Data bit: 8 bit
Parity:
Data bit: 8 bit
Parity:
no
Stop bit: 1 bit
5) Connection
6) Protocol
From the PC to the display
Straight Cable
* D-sub 9-pin/D-sub 25-pin conversion tables are now available on the market.
Control PC
Plasma Display
Control PC
Plasma Display
(with D25 serial port )
(PDP-425CMX/PDP-42MXE10)
(with D9 serial port)
(PDP-425CMX/PDP-42MXE10)
2
2
3
3
2
3
2
RXD 3
2 TXD
RXD 2
2 TXD
TXD 2
3 RXD
TXD 3
3 RXD
CTS 5
8 RTS
CTS 8
8 RTS
GND 7
5 GND
GND 5
5 GND
5
9
6
1
Pin No.
Signal
1
NC (not connected)
2
TxD (Transmit Data)
3
RxD (Receive Data)
4
NC (not connected)
5
GND
Pin No.
Signal
6
NC (not connected)
7
NC (not connected)
8
RTS (Request To Send)
9
NC (not connected)
(1) Sending one command at a time:
STX (02 hex)
ID (2 Byte)
COMMAND (3 Byte or 6 Byte)
ETX (03 hex)
(2) Sending numerical direct commands:
STX (02 hex)
ID (2 Byte)
COMMAND (3 Byte)
ARGUMENT (3 Byte)
ETX (03 hex)
ID, COMMAND, ARGUMENT are transmitted as ASCII characters.
From the display to a PC
(1) Echo back (Normal response)
Command received and returned but the ID is not returned.
(1) Echo back (Normal response)
Command received and returned but the ID is not returned.
STX (02 hex)
COMMAND (3 Byte or 6 Byte)
ETX (03 hex)
Received command is a numerical direct effect command and numerical data is returned:
STX (02 hex)
COMMAND (3 Byte)
ARGUMENT (3 Byte)
ETX (03 hex)
(2) Error (Abnormal response)
Received command is a non-corresponding command, ‘ERR’ is returned:
Received command is a non-corresponding command, ‘ERR’ is returned:
STX (02 hex)
ERR (3 Byte)
ETX (03 hex)
Received command cannot be processed (when PON is received when the power is already ON, etc.), ‘XXX’ is
returned:
returned:
STX (02 hex)
XXX (3 Byte)
ETX (03 hex)