Planet Technology ICA-100 Manuale Utente
Installation
7
Figure 2-1: Camera Stand
Hardware Install Procedure
ICA-100
1.Connect an Ethernet cable
Connect one end of an Ethernet cable to the LAN port located on the ICA-100 rear
panel and attach the other end to the network device (hub or switch).
panel and attach the other end to the network device (hub or switch).
2.Attach the external power supply
Connect the provided power adapter to the ICA-100
’s connector labeled "5VDC" on
rare panel.
3.Check the LEDs
The PWR and ACT LEDs should be on.
ICA-100W
1.Attach Wireless Antenna (LAN+WLAN or WLAN mode)
Screw the 2 external Antenna provided into the antenna connector located on ICA-
100W
100W
’s rear panel.
2.Connect an Ethernet cable (LAN or LAN+WLAN mode)
Connect one end of an Ethernet cable to the LAN port located on the ICA-100W
’s rear
panel and attach the other end to the network device (hub or switch).
3.Switch to appropriate network type
Select the desired Network communication type for ICA-100W from the Slide Switch.
Position the Slide Switch to the setting required.
Position the Slide Switch to the setting required.
4.Attach the external power supply
Connect the provided power adapter to the ICA-100W
’s connector labeled "5VDC" on
rare panel.
5.Check the LEDs
The PWR and ACT LEDs should be on.