Peerless Industries PRS-UNVP-S Manuale Utente

Pagina di 12
ISSUED: 09-19-05  SHEET #: 055-9441-5 10-31-08
Visit the Peerless Web Site at www.peerlessmounts.com
2 of 12
For customer care call 1-800-729-0307 or 708-865-8870.
Table of Contents
Parts List .......................................................................................................................................................................... 3
Installation to Extension Columns / Ceiling Plate .............................................................................................................. 4
Installation to Wood Joist Ceilings .................................................................................................................................... 5
Installation to Concrete Ceilings ........................................................................................................................................ 6
Installation to Threaded Rods ............................................................................................................................................ 7
Attaching Adapter Plate to Projector ................................................................................................................................. 8
Projector Alignment ........................................................................................................................................................ 10
Accessories .............................................................................................................................................................. 11, 12
Tools Needed for Assembly
• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill
Note: Read entire instruction sheet before you start installation and assembly.
• 1/4" bit for concrete surface
• 5/32" bit for wood studs
• level
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum Load Capacity. See page 1.
• If mounting to wood ceiling studs, make sure that mounting screws are anchored into the center of the studs. Use of
an "edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with the
hardware included in this product as specified in the installation sheet. To mount this product to an alternative support-
ing surface, contact Peerless customer care at 1 800 865-2112.
• This product was designed to be installed on the following ceiling construction only;
CEILING CONSTRUCTION
ADDITIONAL HARDWARE REQUIRED
x
Wood Stud
None
x
Wood Beam
None
x
Solid Concrete
None
Cinder Block
Contact Customer Service
Metal Stud
Contact Customer Service
Brick
Contact Customer Service
Other or unsure?
Contact Customer Service
WARNING