Philips az156017 Manuale Utente

11

• For FM, pull out the telescopic antenna.

Incline and turn the antenna. Reduce its length if the signal is
too strong (very close to a transmitter).

• For AM, the set is provided with a built-in antenna so the

telescopic antenna is not needed. Direct the antenna by
turning the whole set.

You can store up to a total of 30 tuner stations in the memory. 
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
™ Display: 

flashes.

3. Press PRESET

3 or 4 once or more to allocate a number from

1 to 30 to this station.

4. Press PROG again to confirm the setting.
™ Display: 

disappears, the preset number and the frequency

of the preset station are shown.

5. Repeat the above four steps to store other stations.
• You can overwrite a preset station by storing another

frequency in its place.

Press TUNER PRESET

4 or 3 until the desired preset station is

displayed.

In North and South America the frequency step between adjacent
channels in the AM and FM band are 10 KHz and 100 KHz
respectively. In the rest of the world this step is 9 KHz and 50 KHz.
Usually the frequency step has been preset in the factory for your
area.
1. Check that the set is in the TAPE/OFF position and switched

off.

2. To select 9KHz : Simultaneously, press PROG and REPEAT
3. Switch the set on to TUNER and then release the controls.
• To select 10KHz: Repeat steps 1-3 but in step 2,

simultaneously, press PROG and TUNING

§ on the set. 

™ When you tune to radio stations, the display shows tuning in

either steps of 9 or 10.

™ All preset stations will be affected and you may need to

reprogram the preset stations.

AZ 1560 /17  

page

11

XP AZ 1560/17  19-09-2000 13:06  Pagina 11