Philips pss-2000br-ss Manuale Utente

Pagina di 7
Instruction Manual
Swivel Stand
3
DISPLAY PREPARATION PROCEDURES
Prepare the display for installation as follows:
1.
Install the PSB bracket (shipped with the PSS) on your 
display according to the instructions included in PSB 
bracket package.
STAND ASSEMBLY PROCEDURES
Free Standing (not anchored) Applications Only:
NOTE: Do not perform this step if you are going to anchor 
the stand to a surface.
1.
Install five rubber bumpers on the bottom of the stand 
(see Figure 1).
Display Measuring 30 Inches or Smaller In Height:
NOTE: Stand comes assembled for displays 30” in height or 
less and lowered to its minimum height for shipment.
1.
Loosen the four height adjustment screws and raise the 
slide to its maximum height (see Figure 2).
2.
Secure the slide in place by tightening the four height 
adjustment screws.
Display Measuring More Than 30 Inches In Height:
1.
Remove the slide from the base by removing four height 
adjustment screws (see Figure 3).
2.
Remove the front plate from the slide by removing two 
nuts securing the front plate (see Figure 3).
3.
Install the front plate in the upper mounting holes of slide 
and secure using the two nuts removed in the previous 
step (see Figure 4).
4.
Install the slide on the base using the four height adjust-
ment screws (see Figure 3).
5.
Raise the slide to its maximum height (see Figure 2).
6.
Secure the slide in place by tightening the four height 
adjustment screws.
Figure 1. Free Standing Installations Only
Figure 2. Height Adjustment
Adjust height using these screws
Attach rubber bumpers here