Garmin g1000 beechcrafta36 g36 nav com pilots guide Manuale Utente
Garmin G1000 NAV/COM Pilot’s Guide for the Beechcraft A36/G36
190-00572-00 Rev. A
4-9
OPERATION – NAV
4.3 NAV OPERATION
FREQUENCY RANGE
The G1000 NAV radios receive in the VOR/ILS
frequency range of 108.00 to 117.95 MHz with 50 kHz
spacing. The NAV Frequency window displays the
following information:
spacing. The NAV Frequency window displays the
following information:
• NAV1 and NAV2 active and standby frequencies
• NAV1 and NAV2 identifier indication
• NAV1 and NAV2 identifier indication
(if the Morse
code identifier is received by the system)
• Color-coded indication of the selected NAV radio
• Morse code identifier status
• Morse code identifier status
MORSE CODE IDENTIFIER
Press the VOL/PUSH ID knob to turn the Morse code
identifier ON and OFF. When the identifier is ON, a
white ID indication appears to the left of the active NAV
frequency, and the Morse code is heard on the NAV audio.
The VOR/LOC Morse code identifier is displayed next to
the active NAV frequency.
white ID indication appears to the left of the active NAV
frequency, and the Morse code is heard on the NAV audio.
The VOR/LOC Morse code identifier is displayed next to
the active NAV frequency.
When the identifier is OFF, the ID indication disappears
and the Morse code is off.
NAV audio is available with the ID filtered out for
listening to HIWAS and FSS transmissions on VOR
stations.
stations.
NAV section
of the audio
panel
NAV2 radio is selected on the
audio panel. The Morse code
identifier for the GHM VOR
can be heard.
Figure 4.3.1 Morse Code Identifier Audio
NAV RADIO SELECTION FOR NAVIGATION
The desired NAV radio is selected for navigation by
pressing the CDI softkey located on the PFD. The three
navigation modes that can be selected are:
navigation modes that can be selected are:
• VOR1 (or LOC1) – If NAV1 is selected, a single
green arrow (shown) labeled either ‘VOR1’ or
‘LOC1’ is displayed on the HSI and the active NAV1
frequency is displayed in green.
‘LOC1’ is displayed on the HSI and the active NAV1
frequency is displayed in green.
• VOR2 (or LOC2) – If NAV2 is selected, a double
green arrow (not shown) labeled either ‘VOR2’ or
‘LOC2’ is displayed on the HSI and the active NAV2
frequency is displayed in green.
‘LOC2’ is displayed on the HSI and the active NAV2
frequency is displayed in green.
• GPS – If GPS mode is selected, a single magenta
arrow (not shown) appears on the HSI and neither
NAV radio is selected.
NAV radio is selected.
NOTE: In GPS mode, both active NAV frequencies
are displayed in white.
are displayed in white.
Figure 4.3.2 Selecting a NAV Radio
The NAV radio is
selected by the CDI
softkey.