Maytag ls7806s Manuale Utente

•  Unevenly distributed load.  Redistribute the load, close the lid and pull knob

out.  Check for leveling.  Be sure water level is acceptable for load size.

•  Plug cord into live electrical outlet.
•  Check fuse or reset circuit breaker.
•  Turn the control knob to proper cycle and pull knob out to start the washer.

If equipped with buttons, be sure they are fully depressed.

•  Close lid and pull control knob out to start the washer.  For your safety, wash-

er will not fill, agitate or spin unless lid is closed.

•  This may be a pause or soak period in the cycle.  Wait briefly and it may start.

•  Make sure hose connections are tight.
•  Make sure end of drain hose is correctly inserted and secured to drain 

facility.

•  Avoid extended soaking – soak for 30 minutes or less.
• Avoid overloading.

•  Be sure washer is leveled properly as outlined in installation manual.
•  Weak floors can cause vibration and walking.
• Be sure rubber feet are installed on leveling legs.

•  Turn both faucets on fully.
•  If equipped with a temperature selector knob, be sure it is set directly on a

temperature setting and not between settings.

•  Make sure temperature selection is correct.
•  Make sure hoses are connected to correct faucets and inlet connections.

Flush water line before filling washer.

•  Check the water heater.  It should be set to deliver a minimum 120°F (49°C)

hot water at the tap.  Also check water heater capacity and recovery rate.

•  Disconnect hoses and clean screens.  Hose filter screens may be plugged.