Maytag MSD2722GRQ Manuale Utente

• the temperature control turned to “Off”
• the power cord not plugged in
• no power at the electrical outlet
• the circuit breaker tripped or the house fuse blown
• refrigerator is in automatic defrost

• modern refrigerators are larger and run colder, which requires more running time to

provide more stable temperatures

• prolonged door openings
• the base grille blocked
• too many door openings
• the door not sealing (due to a package or a container holding door open)
• warm room temperature

• the cabinet not level
• a weak floor

• odor producing foods should be covered or wrapped
• the interior needs cleaning

• normal air flow for condenser circulation

• the cabinet not level
• a weak floor

• can occur during hot, humid weather with frequent or prolonged door openings
• door not closed properly

• food not wrapped properly
• hot, humid weather

• the normal setting has been chosen
• the drawer has not been opened for four weeks

• for best results, refrigerator and freezer controls should be set at the mid (5) levels
• After drawer openings, the addition of a new load or changing settings, the readout

may vary. The temperature will recover in a short period of time.

• the refrigerator or freezer control set too warm
• prolonged door openings

• the refrigerator control set too cold

• a normal sound caused by defrost water dripping on defrost mechanism

• the appearance of a red glow or reflection is normal during the defrost cycle

• products with high sugar content may not harden completely when frozen (ice cream,

concentrated juice, etc.)

• adjust freezer control to a colder setting

• This is normal.  The control will count down 12 months or 416 gallons whether the

filter or the filter bypass is in place.  Reset the light (see pg. 11)

• cold air moving over the ice cubes causes shrinkage, especially with limited usage.

This is normal

• the stop arm in OFF (up) position
• the water supply turned off
• the water pressure too low
• the freezer too warm

• special design to limit condensation during periods of high humidity

• ice jam in the dispenser
• ice maker not operating
•  lock switch on (see page 11)

•  water supply turned off
•  water pressure too low
•  lock switch on (see pg. 11)