Danby DWC310BL Manuale Utente

Remove the exterior and interior packings, wipe the outside
thoroughly with a soft dry cloth and the inside with a wet,
lukewarm cloth.  Avoid placing the cabinet in a narrow recess or
near any heat source, direct sunlight, or moisture.  Let air
circulate freely around the cabinet.  Keep the rear of the wine
cooler 5 inches away from the wall.

1. Select a place with a strong, level floor.

2. Allow 5 inches of space between the back of the wine cooler

and any adjacent wall.

3. Avoid direct sunlight and heat.  Direct sunlight may affect the

acrylic coating.  Heat sources nearby will cause higher
electricity consumption.

To avoid vibration, the cabinet must be set level.  To start the
wine cooler, turn the temperature control to the position
corresponding to the desired cooling.  The wine cooler
temperature will vary depending on the quantity of bottles stored
and on the frequency with which the door is opened.

Setting The Temperature Control:

The temperature of the wine cooler compartment is controlled by
adjusting/setting the thermostat control knob, located on the
exterior rear wall of the cabinet.

To start the wine cooler and achieve maximum

cooling quickly;

• Turn the temperature control knob clockwise to the furthest
(maximum) setting on the darker blue (wide) section of the
graduated control dial.

• Allow the unit to run at this setting for 3-4 hours. 

• When maximum cooling is achieved, turn back the temperature
control knob setting to the 2 o’clock position on the graduated
blue control dial. See fig.15.

• To turn off the wine cooler, (no cooling) rotate the control knob
to the “0” (off) position. See fig.14

Turn the control to the “OFF” (0) position to temporarily
disconnect the cooling cycle.  When the wine cooler is not to be
used for a long period of time, disconnect the plug and leave the
door partially open.

This appliance must be grounded.  In 
the event of an electrical short circuit, 
grounding reduces the risk of electrical shock by providing
an escape wire for the electrical current.  This appliance is
equipped with a cord having a grounding wire with a
grounding plug.  The plug must be plugged into an outlet
that is properly installed and grounded.

Improper use of the 

grounding plug can result in a risk of electric shock.
Consult a qualified electrician or serviceman if the
grounding instructions are not completely understood, or if
the doubt exists as to whether the appliance is properly
grounded.

Use an exclusive wall outlet.  Do not connect your wine
cooler to extension cords or together with any other
appliance in the same wall outlet.  Do not splice the cord.

An empty wine cooler is a very dangerous attraction to
children.  Remove either the gasket, latches, lids or doors
from unused appliances, or take some other action that
will guarantee it harmless.

2

You must remove the bottom door support on the bottom left
hand side of the unit before you can open the door. (See Fig. A)

Fig. 14

Fig. 15