Garmin 90-140 Manuale Utente

I

NSTALLING

 Y

OUR

 F

ISHFINDER

 > 

I

NSTALLING

 

THE

 T

RANSDUCER

1.   Position the transducer mount at the selected 

transom location. Make sure the transducer is 

parallel with the water line. Mark the center locations 

of each hole on the transducer mount. (See the 

figures on the next page.)

2.   Using a 5/32" bit, drill the pilot holes approximately 

1" (25 mm) deep at the marked locations. To avoid 

drilling the holes too deep, wrap a piece of tape 

around the bit at 1" from the point of the bit. 

3.   Apply marine sealant to the 5 x 30 mm screws. 

Attach the transducer assembly to the transom 

using the 5 x 30 mm screws. Adjust the transducer 

assembly to extend beyond the bottom of the 

transom approximately 1/8" (3 mm) on fiberglass 

hulls or 3/8" (10 mm) on aluminum hulls. Adjust the 

transducer assembly to be aligned parallel with the 

water.

4.   Tighten the 10-32 locking nut until it touches the 

mounting bracket, and then tighten 1/4 turn more. 

(Do not overtighten.)

5.   Place the first cable clamp on the transducer cable 

approximately one third of the distance between 

the transducer and the top of the transom. Mark 

the location. Using a 1/8" bit, drill a pilot hole 

approximately 3/8" (10 mm) deep.

6.   Attach the cable clamp using a 4 x 12 mm screw. 

Coat the screw with marine sealant before 

installation. Repeat steps 5 and 6 using the other 

cable clamp. 

7.  Route the transducer cable, as needed, to the 

Fishfinder. DO NOT CUT THE CABLE. Avoid routing 

the cable with electrical wires or other sources of 

electrical interference.