Intermatic sp501b Manuale Utente

BATTERY INSTALLATION (SEE FIGURES BELOW)
Access the battery compartment on the rear of the unit by removing
the back cover. Press on the upper center part of the cover and slide it
down. Insert four (4) “AA” batteries (not included) following the polar-
ity diagram. When the last battery is inserted, the Status LED will flash
and the LED will flash to indicate the batteries are installed 
properly. Replace the battery compartment cover. The Siren will chirp
every 10-15 seconds when the batteries need replacing. AC accessory
SP550B can be used instead of batteries. Output plug must be inserted
into AC power plug, located above in left upper corner of battery
compartment.

BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries 

as indicated in the battery compartment. Reversed batteries may 
cause damage to the device.

3. Do not mix different type of batteries together (e.g. Alkaline and 

Carbon-zinc) or old batteries with fresh ones.

4. If the device is not to be used for a long period of time, remove the 

batteries to prevent damage or injury from possible battery 
leakage.

5. Do not try to recharge batteries not intended to be recharged; 

they can overheat and rupture. (Follow battery manufacturer’s 
directions.)

6. Will not function properly if batteries are not maintained. Check 

performance regularly.

NOTE: Not intended for use in exposed outdoor applications. Will not
operate properly if used in below freezing temperatures (32˚F) or damp 
locations.

Siren Speaker Unit 

INSTRUCTIONS

1. Speakers
2. Status LED
3. Battery Compartment
4. Programmable Switch

PROGRAMMING THE SIREN SPEAKER UNIT
1. Remove battery compartment cover, remove batteries.
2. Locate the programmable switch.
3. Set the “CORRECT SWITCH COMBINATION” on programmable
switch. All 3 switches of the programmable switch must be set at the
same positions as respective switches of the Main Alarm Unit
programmable switch.
4. Replace batteries, replace the battery compartment cover.

INSTALLATION (Siren Speaker Unit)
The unit is designed to be either free standing or
wall mounted. Place the unit in the desired location
within 60’ from the Alarm Unit. To mount the unit
on the wall use the supplied screw (see figure at
right).

WARNING: THE ALARM SIREN IS VERY LOUD;
PLEASE DO NOT ALLOW IT TO SOUND FOR LONG
LENGTHS OF TIME.

WARNING: NOT INTENDED FOR USE AS A
RESIDENTIAL WATER HAZARD ENTRANCE
ALARM.

OPERATION:
The Remote Siren only sounds when triggered by the main alarm unit,
SP210B OR SP230B. Approximately 60 seconds on and 15 seconds
off, the cycle will repeat if main alarm stays in alarm mode.