Multiquip R2000H Manuale Utente
R2000H RIDE-ON STATIC ROLLER — OPERATION & PARTS MANUAL — REV. #4 (07/24/08) — PAGE 21
R2000H — INSPECTION
CAUTION
NEVER operate the roller
in a confined area or
enclosed area structure
in a confined area or
enclosed area structure
that does not provide
ample
ample
free flow of air.
ALWAYS wear approved eye and hearing
protection before operating the roller.
protection before operating the roller.
NEVER place hands or feet inside the guard
rings while the engine is running. ALWAYS
shut the engine down before performing any
kind of maintenance service on the roller.
rings while the engine is running. ALWAYS
shut the engine down before performing any
kind of maintenance service on the roller.
Before Starting
1. Read safety instructions at the beginning of manual.
2. Clean the
roller, removing dirt and dust, particularly the air
filter and carburetor.
3.
Check the air filter for dirt and dust. If air filter is dirty, replace
air filter with a new one as required.
air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with dry
compressed air.
5.
Check fastening nuts and bolts for tightness.
Engine Oil Check
1. To check the engine oil level, place the roller on secure level
ground with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 6) and wipe it clean.
Figure 6. Engine Oil Dipstick (Removal)
3. Insert and remove the dipstick without screwing it into the filler
neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 7), fill to the edge of the oil filler
hole with the recommended oil type (Table 4). Maximum oil
capacity is 400 cc.
Figure 7 Engine Oil Dipstick (Oil Level)
Reference manufacturer engine
manual for specific servicing
instructions.
manual for specific servicing
instructions.
NOTE
Explosive Fuel
CAUTION
Motor fuels are highly flammable and can be
dangerous if mishandled. DO NOT smoke
dangerous if mishandled. DO NOT smoke
while refueling. DO NOT attempt to refuel the
roller if the engine is
roller if the engine is
hot! or running.
Fuel Check
1. Remove the gasoline cap located on top of fuel tank.
2. Visually inspect to see if fuel level is low. If fuel is low, replenish
with unleaded fuel.
3. When refueling, be sure to use a strainer for filtration. DO
NOT top-off fuel. Wipe up any spilled fuel.
e
p
y
T
li
O
.
4
e
l
b
a
T
n
o
s
a
e
S
e
r
u
t
a
r
e
p
m
e
T
e
p
y
T
li
O
r
e
m
m
u
S
r
e
h
g
i
H
r
o
C
°
5
2
0
3
-
W
0
1
E
A
S
ll
a
F
/
g
n
ir
p
S
C
°
0
1
~
C
°
5
2
0
2
/
0
3
-
W
0
1
E
A
S
r
e
t
n
i
W
r
e
w
o
L
r
o
C
°
0
0
1
-
W
0
1
E
A
S