Gary Fisher 2004 gary fisher bicycles Manuale Utente
42
43
CHAPTER THREE
Inspection, Adjustment & Lubrication
To replace the shift cable
1. Remove the bell crank cover set screw (Figure
3.5.4).
2. Remove the bell crank cover.
3. Loosen the cable fixing bolt (Figure 3.5.6).
4. Note the path of the old cable, and remove the
3. Loosen the cable fixing bolt (Figure 3.5.6).
4. Note the path of the old cable, and remove the
cable.
4. Install a new cable in the shifter, housing, and
cable guides, following the old path.
5. Re-attach the cable fixing bolt.
6. Re-attach the cover on the bell crank.
7. Crimp on a metal end-cap to prevent fraying
6. Re-attach the cover on the bell crank.
7. Crimp on a metal end-cap to prevent fraying
of the cable end, or apply some solder to the end of the
cable.
8. Follow the instructions
To adjust the rear shifting.
Lubrication
Once a year,
lubricate the Nexus hub bearings. This
procedure takes special tools and training, so should be done
by your Fisher dealer.
Whenever a cable is replaced
, lubricate the cable with
Wrench Force® synthetic chain lube or a similar lubricant.
Figure 3.56 Bell crank cable
clamp bolt
clamp bolt
Cable
clamp
bolt
Cable
barrel
adjuster