Garmin colorado 400t Manuale Utente

Appendix

A carabiner with a clip comes with the 

Oregon 300 and 400 series units and is 

optional with 200 series units.

1.  Position the carabiner clip in the slots 

on the mounting spine of the Oregon.

2.  Slide the clip up until it locks in place.

To remove the carabiner clip, lift the 

bottom of the clip and slide the carabiner 

clip off the mounting spine.

The Oregon screen does not normally 

require calibration. However, if the 

buttons do not seem to be responding 

properly, use the following process.

1.  While the unit is turned off, press and 

hold the   

 key for 

approximately 30 seconds.

2.  Follow the instructions on the screen 

until “Calibration is complete” is 

displayed.

3.  Touch 

.

BY USING THE OREGON, YOU AGREE 

TO BE BOUND BY THE TERMS AND 

CONDITIONS OF THE FOLLOWING 

SOFTWARE LICENSE AGREEMENT. PLEASE 

READ THIS AGREEMENT CAREFULLY.
Garmin grants you a limited license to use 

the software embedded in this device (the 

“Software”) in binary executable form in the