culligan water tower Manuale Utente

13

Note: Replace battery with a new alkaline 9-volt battery (PN 31300001)

26. Carefully slide battery into its holder.

27. Connect battery by pressing clip onto battery terminals.

28. Test monitor connection by activating monitor. Open product water faucet. If  an

indicator light illuminates, connection is good.

Note: Close faucet immediately after light illuminates. Test confirms battery connection, not
water quality.

29. Install enclosure front panel (Item 3):

a. Place panel in position, aligning push-in tabs  with openings. Verify circuit board

wiring is not pinched between panels.

b. Press panel inward until push-in tabs engage, securing the panel.
c. Check for leaks.

30. Open product water faucet. Let water flow until all air has been expelled from the

system.

31. Close product water faucet. Wait 30 minutes, check connections for leaks, and

correct if  necessary.

Icemaker/Extra point of  use: Check lines for leaks.

32. Allow storage tank to fill overnight.

DO NOT USE FIRST FULL STORAGE TANK OF WATER

33. Discard (to drain) first full tank of  water by opening product water faucet until water

flow stops, then close faucet. This flushes sanitizing solution from system.

Icemaker: Let  tray/bin fill with ice cubes. Discard all ice cubes to drain. This flushes sanitizing
solution from lines in icemaker. Replace delivery device filter (if  applicable).

Note: System is ready to use. Should there be any aftertaste or odor, drain storage tank and
repeat Steps 32 and 33.