Century 44892L Manuale Utente

To prevent serious injury or death:

• Use ONLY the vehicles Lap/Shoulder

Belt system when restraining the child
in this booster seat.

• Shoulder belt

MUST

be properly

positioned over shoulder (

NOT

touching child’s neck and

NOT

low

off shoulder).

• Lap/shoulder belt

MUST

be properly

positioned exactly as shown in
illustration.

• Always tighten shoulder belt. NEVER

position belt under child’s arms (fig. a).

• Never use a vehicle “lap-only” belt

across front of child.

•

DO NOT

allow child to slide down in

car seat which could position lap belt
across child’s abdomen and shoulder
belt over neck or face.

• If child will not keep vehicle shoulder

belt properly positioned,

DO NOT

use

this booster car seat. Use a different
child restraint system.

• Vehicle belts

MUST

lay flat against child

and

MUST

not be twisted.

WARNING

Remove harness system (see “Harness System -
removal and re-assembly”, page 20).

Place child in car seat with child’s back flat
against back of car seat.

Place shoulder belt across child’s chest and
lap belt under both armrests.

Buckle belt and pull shoulder belt to adjust lap
belt snugly.

Shoulder belt MUST lay across child’s shoulder
in red zone as shown (fig. b). If outside of
red zone, see next steps for Comfort Clip

use.

CAUTION:

Some shoulder belts with (emergency
locking) retractors allow a child to pull belt
out and change position of belt. Use of
Comfort Clip® helps prevent child from
pulling belt out.

Thread shoulder belt through Comfort Clip

exactly as shown and hook end of Comfort
Clip

through desired loop of webbing (fig. c).

Check to be sure shoulder belt is properly
positioned over shoulder in red zone and snug
against child.

PLACING CHILD IN CAR SEAT

without

harness system