Homelite 17991f Manuale Utente
2
TURN NOZZLE COUNTERCLOCKWISE TO REMOVE
12. Attach shoulder strap clips at locations shown.
OPERATION
OPERATION
OPERATION
OPERATION
OPERATION
ALWAYS FOLLOW ALL SAFETY PRECAUTIONS LISTED IN
THE BLOWER/VACUUM OWNER’S MANUAL.
THE BLOWER/VACUUM OWNER’S MANUAL.
1. Start engine.
2. Place both the shoulder strap and the leaf bag strap over the head and
2. Place both the shoulder strap and the leaf bag strap over the head and
onto the left shoulder.
3. Hold upper handle in right hand and lower handle in left hand as
illustrated.
OPERATING POSITION
OPERATING POSITION
OPERATING POSITION
OPERATING POSITION
OPERATING POSITION
4. The vacuum can be operated at any speed between idle and full
throttle. The throttle latch may be used to advance throttle for
extended operation. Experience will help determine the amount
of airflow necessary for each application.
extended operation. Experience will help determine the amount
of airflow necessary for each application.
5. Move the unit from side to side along outer edge of debris. To
avoid clogging, do not place vacuum tube directly into debris pile.
6. If vacuum tubes should clog, STOP ENGINE AND REMOVE
SPARK PLUG WIRE before removing vacuum tubes to clean out
obstruction.
obstruction.
7. It may be preferred to use throttle trigger when vacuuming select
areas of leaves- releasing the trigger quickly stems vacuum
suction.
suction.
WARNING
•
Do not operate vacuum without bag securely fastened to
tube.
tube.
•
Do not attach bag directly to blower housing.
•
Do not open, remove or attach bag while engine is
running.
running.
•
Replace worn or weakened bag with manufacturer’s
replacement part.
replacement part.
LEAF BAG
STRAP
STRAP
SHOULDER
STRAP
STRAP
7. Remove nozzle from straight tube.
a) Set unit with nozzle facing you.
b) Turn nozzle counterclockwise.
b) Turn nozzle counterclockwise.
8.
Install vacuum bag over blower tube, ensuring the end of the bag
sleeve is completely covering the rib in the blower tube.
sleeve is completely covering the rib in the blower tube.
9.
Wrap fastening strap tightly around the blower tube and through the
fastening loop. Fasten securely.
fastening loop. Fasten securely.
10. Rotate vacuum bag until shoulder strap is upright.
11. Make sure vacuum bag is zipped/closed before starting the unit.
11. Make sure vacuum bag is zipped/closed before starting the unit.
VACUUM
BAG
BAG
FASTENING
STRAP
STRAP
BLOWER TUBE
FASTENING LOOP
RIB
FASTENING STRAP
STRAIGHT TUBE
NOZZLE