Garmin Ghc 10 Manuale Utente

Though the autopilot is configured for 

your boat during installation, you may 

find it necessary to adjust it slightly 

depending on sea conditions. You may 

also disable the Shadow Drive if you 

prefer.
To access the user autopilot 

configuration, select 

 > 

> 

.

™

—disable or re-enable 

the Shadow Drive.

  CAuTIoN: On a GHP 10 autopilot 

system, if you disable the Shadow 

Drive, you will need to place the 

autopilot on standby (

) to 

manually control the helm. Use 

caution when disabling the Shadow 

Drive.

On a GHP 10V autopilot system, if you 

disable the Shadow Drive, any

adjustment to the helm completely 

disengages the autopilot.
Shadow Drive Sensitivity—on a 

GHP 10 autopilot system, adjust this 

setting if the Shadow Drive is being 

tripped falsely or not activating properly. 

If the autopilot disengages while the 

helm is steady, decreasing this value 

may help. If the Shadow Drive does not 

disengage the autopilot correctly when 

you take the helm, increasing this value 

may help. This setting does not apply to 

a GHP 10V autopilot system

.

Sea State Filtering—adjust this setting 

to slow the heading response down 

and reduce rudder activity. Leave this 

setting at 0% under normal operating 

conditions, and increase it when 

operating the autopilot in choppy seas 

at low speeds. Increasing the Sea State 

Filtering setting in choppy conditions 

will save wear on your autopilot system.