Garmin g1000 beechcraftbaron58 g58 pilots guide Manuale Utente
Garmin G1000 MFD Pilot’s Guide for the Beechcraft 58/G58
190-00629-00 Rev. B
7-139
MULTI FUNCTION DISPLAY
To select the Nearest Airspaces Page:
1. From any page, press and hold the CLR key to
select the Navigation Map Page.
2. Turn the large FMS knob to select the ‘NRST’
page group. ‘NRST’ is displayed in the page
group icon located in the lower right corner
of the display.
group icon located in the lower right corner
of the display.
3. Turn the small FMS knob to select the Nearest
Airspaces Page.
Airspace Alerts Box
The Airspace Alerts Box displays the Airspace Name,
Status, and Time to Entry. The status and time to entry (if
applicable) is based on the following conditions:
applicable) is based on the following conditions:
• If the projected course will take the aircraft inside
an airspace within the next ten minutes, the status
field shows the airspace as ‘Ahead’.
field shows the airspace as ‘Ahead’.
• If the aircraft is within two nautical miles of an
airspace and the current course will take the
aircraft inside, the status field shows the airspace
as ‘Ahead < 2 nm’.
aircraft inside, the status field shows the airspace
as ‘Ahead < 2 nm’.
• If the aircraft is within two nautical miles of an
airspace and the current course will not take the
aircraft inside, the status field shows ‘Within
2 nm’.
aircraft inside, the status field shows ‘Within
2 nm’.
• If the aircraft has entered an airspace, the status
field shows ‘Inside’.
NOTE The airspace alerts are based on three-
dimensional data (latitude, longitude and
altitude) to avoid nuisance alerts. The alert
boundaries for controlled airspace are also sec-
tored to provide complete information on any
nearby airspace. Once the described conditions
exists, the status and time of entry is shown if
the airspace alert messages are enabled on the
System Setup Page (Auxiliary Page Group).
dimensional data (latitude, longitude and
altitude) to avoid nuisance alerts. The alert
boundaries for controlled airspace are also sec-
tored to provide complete information on any
nearby airspace. Once the described conditions
exists, the status and time of entry is shown if
the airspace alert messages are enabled on the
System Setup Page (Auxiliary Page Group).
By selecting any airspace name listed on the Nearest
Airspaces Page, additional details are provided —
including controlling agency, communication frequencies
and floor/ceiling limits.
including controlling agency, communication frequencies
and floor/ceiling limits.
To view additional details for an airspace
listed on the Nearest Airspaces Page:
listed on the Nearest Airspaces Page:
1. Select the Nearest Airspace Page.
2. Press the FMS knob to activate the cursor.
3. Turn the large FMS knob to scroll through the
2. Press the FMS knob to activate the cursor.
3. Turn the large FMS knob to scroll through the
list, highlighting the desired airspace.
4. Press the ALERTS softkey and turn the FMS
knob to select the desired airspace.
5. The remaining information on the Nearest Air-
spaces Page pertains to the selected airspace
name.
name.
6. Press the FMS knob to remove the flashing
cursor.
To view and quickly load the frequency for
a controlling agency:
a controlling agency:
1. Select the Nearest Airspaces Page.
2. Press the FREQ softkey and turn the FMS knob
2. Press the FREQ softkey and turn the FMS knob
to select the desired frequency. Press the
ENT
key to load the frequency into the ‘COM’ fre-
quency standby field
quency standby field