Garmin gpsmap 3006c Manuale Utente

83

83

Once the data card has 
been read, a sum-
mary screen appears. 
Press ENTER/MARK to 
acknowledge.

The GPSMAP 3006C/3010C uses optional Garmin marine BlueChart and MapSource data cards to dis-

play digital charts and maps on-screen. Data cards are installed in the card slot located at the bottom right 
of the unit. Data cards may be installed or removed at any time, whether the unit is on or off.

1.  Open the card door by pressing the locking tab on the door towards the outside (left) of the unit and lifting 

the door open from right to left.

2.  Insert the card into the slot, with the label facing to the right and the handle towards you.

3.  Firmly push the card into the unit. It in not necessary to force the card and about 1/2” is still exposed when 

it is properly inserted. If the unit is on, a confi rmation tone sounds and a message displays on the screen 
noting the card details when the card has been properly installed and accepted.

4.  Close the cover until it locks.

If you insert a data card and get a ‘card format not recognized’ message, try removing the card and 

reinserting it. If the card is still not recognized, contact the Garmin or your Garmin dealer for assistance. 
Data cards are not waterproof, should not be exposed to moisture or excessive static charges, and should 
be stored in the case supplied with the card.

1.  Open the card door by pressing the locking tab on the door towards the outside (left) of the unit and lifting 

the door open from right to left.

2.  Grasp the card handle and pull out fi rmly.

3.  If the unit is on, a confi rmation tone sounds when the data card has been removed. 

The fi rst time you insert a 
data card, the unit takes 
a few seconds to read the 
card.