Garmin 190-00556-10 Manuale Utente

U

NIT

 O

VERVIEW

 > 

V

EHICLE

 I

NSTALLATION

To remove the Quest from the mount, gently pull the release tab on 

the top of the mount up and remove the Quest. 
The cradle and suction mount snap apart and back together. To 

remove the mount from the cradle, turn the cradle as far as you can 

to the right or left. Apply pressure in that direction until the mount 

pops out of the ball socket. 
To remove the mount from the windshield, flip the lever toward 

you. Pull the rubber tab on the suction cup toward you.

Use the enclosed mounting disk as an alternative to using the 

suction cup mount on your windshield. Select a suitable location on 

your dashboard to place the mounting disk. Select a location where 

the unit has an unobstructed view of the sky and does not interfere 

with the driver’s view of the road or obstruct any controls in the 

vehicle. 
WARNING: The mounting disk affixes to your dashboard with 

permanent adhesive that is extremely difficult to remove after it is 

installed. 

1.  Clean and dry the area on your dashboard where you want 

to place the mounting disk.

2.  Remove the backing from the permanent mounting 

adhesive on the bottom of the disk and place the disk on the 

dashboard. Press firmly for several seconds.

3.  Pull the lever on the suction cup up (away from the disk). 

Place the suction cup mount on top of the disk. 

4.  Flip the lever down (toward the disk) to secure the suction 

cup mount to the disk.