Garmin gpsmap 400 Manuale Utente

c

onfIGurInG

 

the

 u

nIt

 

Use the Configure screen to configure unit settings.

To change general system settings, from the Home screen, select 

 > 

.

Simulator—turn Simulator Mode on or off and set Simulator Mode 

options. (If you set the unit into a Store Demonstration mode during 

the initial unit setup, this setting will be named Demo.)
Language—select the on-screen language.
beeper/Display—select 

 to set when the unit makes audible 

sounds. The three settings are 

, 

 (default), and 

(keys and alarms). Select 

 to switch between Day or Night 

modes and brighten or darken the backlight.
GPS—view GPS satellites, turn WAAS/EGNOS on or off, and 

initialize the GPS receiver.
System Information—view system information and restore factory 

settings.
Event Log—shows a list of system events.
Overlay Numbers—set the styles for Wind and Next Turn numbers.

To change units of measure, from the Home screen, select 

 > 

.

System Units—this is a quick global setting that defines most of 

 the individual units of measure, listed below, at once. 

  

, 

 

, or 

.

Depth—individually set the units of measure for depth to 

, 

, or 

. 

Temperature—individually set units of measure for temperature to 

 or 

.

  NOTE: You must be receiving NMEA Sonar depth data or using a 

Garmin sounder module to view depth and temperature information.

Dist, Spd, Elev—individually set the units of measure for distance, 

speed, and elevation readings.
Heading—set the reference used in calculating heading information.
Position—change the coordinate system in which a given location 

reading appears. The default format is hdddºmm.mmm'. Only 

change the position format if you are using a map or chart that 

specifies a different position format.
Time—set the time format (

, 

 or 

 time format), 

time zone, and indicate whether to use Daylight Saving Time.