Garmin gpsmap 2006, 2010 Manuale Utente

Pagina di 84
10
Getting Started
Main Page Sequence
10
Getting Started
Basic Navigation
To Create a Waypoint Using the Map Pointer:
1.  With the Map Pointer at the desired location (not on a road or map feature), quickly press and release 
the 
ENTER/MARK
 key. (Holding the ENTER/MARK key for more than one second will mark your present 
location. See pg. 6) The “New Map Waypoint” Page will be displayed.
Change the waypoint name to “MAP 1”, and assign the ‘Information’ symbol. Save the waypoint by 
highlighting the ‘OK’ button and pressing the ENTER/MARK key. Press the QUIT key to hide the Map 
Pointer and center the display on the current GPS location.
Navigating to a waypoint
When you begin navigation to a waypoint, the GPS sets a straight line course to that point. The unit 
will draw a Course Line on the display between the current GPS location and the destination waypoint. 
You may use any of the main pages for navigation. All of these pages are discussed in detail in the Reference 
section of this manual. For this exercise, let’s use the Highway Page.
Going to a waypoint:
1.  Press the 
NAV
 key.
2.  Highlight ‘Go To Point’ and press the 
ENTER/MARK
 key.
3.  Highlight ‘Waypoints’ and press the 
ENTER/MARK
 key. This will display the ‘Select Waypoint’ window. 
From this window you can select waypoints “By Name”, or by “Nearest From Current Location”. Select the 
tab ‘By Name’ using the 
ARROW KEYPAD
.
4.  Using the 
ARROW KEYPAD
, scroll through the list until the waypoint “Map 1” is highlighted. Press the 
ENTER/MARK
 key to display the “Waypoint Review” Page. 
5.  With the ‘Go To’ button highlighted, press the 
ENTER/MARK
 key to begin navigation.
For a GPS to navigate it has to be moving. When the Compass Page or Highway Page is displayed and 
the unit is in the Simulator Mode, you can set a simulated speed by pressing the ARROW KEYPAD ‘Up’.  
Each time the ARROW KEYPAD is pressed ‘Up’ the simulated speed will increase by ten knots. Pressing 
the ARROW KEYPAD ‘Down’, will decrease the simulated speed by the same amount. 
Press the PAGE key until the Compass Page is displayed. Along the right side of the display there 
are four data fi elds, the top fi eld is the Speed.  Press the ARROW KEYPAD ‘Up’ one time to set a 
speed of 10 knots. 
2006-2010 Intro.indd
2/27/02, 9:09 AM
10