Garmin 4010 Manuale Utente

Configuring the Chartplotter

Anchor Drag—set an alarm to sound when you exceed a specified drift distance.
Off Course—set an alarm to sound when you are off course by a specified distance. 

To set a system alarm, from the Home screen, select 

 > 

 > 

.

Clock—set an alarm using the system (GPS) clock. The unit must be on for the clock alarm to work.
Battery—set an alarm to sound when the battery reaches a user-determined low voltage.
GPS Accuracy—set an alarm to sound when the GPS location accuracy falls outside the user-

determined value.

To set a sonar alarm, from the Home screen, select 

 > 

 > 

.

  NOtE: You must have an optional sonar module (and a transducer connected to the sounder module) 

wired through NMEA 0183 or connected to the Garmin Marine Network to receive sonar information.

Shallow Water—set an alarm to sound when the depth is less than the specified value.
Deep Water—set an alarm to sound when the depth is greater than the specified value.
Water temp—set an alarm to sound when the transducer reports a temperature that is 2°F (1.1°C) 

above or below the specified temperature.
Fish—set an alarm to sound when the unit detects a suspended target of the specified symbols.

 — sounds an alarm for all fish sizes
 — sounds an alarm for medium and large fish only
 — sounds an alarm for large fish only

You can configure your chartplotter to sound an alarm when the total amount of remaining onboard 

fuel reaches the level you specify.

  NOtE: To receive fuel-level information, your unit must be connected to an external fuel sensor, such 

as the Garmin GFS 10.

1.  From the Home screen, select 

 > 

 > 

 > 

 > 

.

2.  Use the 

 (GPSMAP 4000 series) or onscreen keyboard (GPSMAP 5000 series) to 

indicate the fuel level at which the alarm should sound.

From the Home screen, select 

 > 

 > 

 > 

 > 

.

To configure settings for your boat, from the Home screen, select 

 >

.

Auto Guidance—set the Auto Guidance parameters for your boat:

Safe Depth—set the minimum depth (chart depth datum) to allow when calculating an auto 

guidance path. A safe depth of less than one meter is not allowed when using Auto Guidance.