Garmin apollo sl30 comm Manuale Utente

Position the cam lock as shown below. The front lobe of the cam should be vertical. The cam 
lock mechanism should be fully unscrewed (turned counter-clockwise). Slide the unit into the 
frame. Turn (clockwise) and carefully hand-tighten (4 in-lb max.) the cam lock mechanism 
using only the 3/32" hex driver provided in the installation package. Using a larger tool than 
the one provided makes it easy to exceed the allowable torque on the cam lock resulting in 
damage to the unit. The unit will be pulled into the frame securing the unit and the connectors 
when fully engaged. Do NOT overtighten. The back of the bezel must be flush to the 
mounting tube. If the cam lock is hard to turn or the unit does not seat fully, the unit is 
probably binding and the mounting tube should be checked.  

To remove the unit from the mounting frame, turn the screw counter-clockwise with the hex 
driver to unscrew the cam lock mechanism. The unit will begin to pull away from the 
mounting tube. Turn the screw until slight resistance is felt and then pull the unit from the 
frame. Do not exert excessive turning force at the end of the cam lock travel or the unit 
may be damaged. With the cam lock fully disengaged, pull the unit straight out holding onto 
the sides of the bezel. It is not recommended that you pull the unit out by the rotary knobs. No 
special extraction tools are required, if the mounting tube is properly installed.