Hoshizaki F-300BAF Manuale Utente

49

1. This icemaker must be maintained individually, referring to the instruction
     manual and labels provided with the icemaker.
. To have the optimum unit performance, the following parts need periodic 

inspection and maintenance:

Extruding Head and Upper Bearing 
Housing and Lower Bearing
Mechanical Seal
Auger
Evaporator Cylinder
Gear Motor

These parts should be inspected at least once a year or every 10,000 hours 
of operation. Their service life, however, depends on water quality and 
environment. More frequent inspection and maintenance are recommended in 
bad or severe water conditions.
Replacement of the following consumable parts is recommended if wear
exceeds factory recommendations:
 

Upper Bearing

 

Lower Bearing

 

Mechanical Seal 

Consult with your local distributor about inspection and maintenance service. 
To obtain the name and phone number of your local distributor, call Hoshizaki 
Technical Support at 1-800-33-1940.

To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a
damp cloth containing a neutral cleaner to wipe off oil or dirt build up.

• Wash your hands before removing ice. Use the plastic scoop provided (bin accessory).
• The storage bin is for ice use only. Do not store anything else in the bin.
• Keep the scoop clean. Clean using a neutral cleaner and rinse thoroughly.
• Clean the bin liner using a neutral cleaner. Rinse thoroughly after cleaning.

A plastic mesh air filter removes dirt or dust from the air, and keeps the condenser from 
getting clogged. As the filter gets clogged, the icemaker’s performance will be reduced. 
Check the filter at least twice a month. When clogged, use warm water and a neutral 
cleaner to wash the filter.

Check the condenser once a year, and clean if required by using a brush or vacuum 
cleaner. More frequent cleaning may be required depending on the location of the 
icemaker.