Philips wet and dry electric shaver RQ1280/22 RQ1280/22 Manuale Utente
Codici prodotto
RQ1280/22
Problem
Possible cause
Solution
The shaver is not entirely
clean after I clean it in the Jet
Clean System.
The cleaning fluid in the cleaning chamber is soiled.
Empty and rinse the cleaning chamber.
The cleaning fluid level is too low. If the fluid volume in
the cleaning chamber drops below the minimum level
during the cleaning program, the program aborts.The
cleaning light and the ‘cleaning chamber empty’ symbol
flash at intervals and the holder returns to its starting
position.
Refill the cleaning chamber with cleaning fluid to
a level between the two lines (see chapter
‘Cleaning and maintenance’).
You have used another cleaning fluid than the original
Philips cleaning fluid.
Only use HQ200 Philips Cleaning Fluid.
The Jet Clean System does
not work when I press the
on/off button.
The Jet Clean System is not connected to the mains.
Put the small plug in the Jet Clean System and
put the adapter in the wall socket.
You have not placed the shaver in the Jet Clean
System properly, so there is no electrical connection
between the Jet Clean System and the shaver.
Press the shaver tightly into the holder to lock it
into place.
The shaver is not fully charged
after I charge it in the charger/
Jet Clean System.
You have not placed the shaver in the charger/Jet Clean
System properly.
Make sure you press the shaver until it locks into
place.
RQ1008: The operating time
of the Jet Clean System is
suddenly shorter or longer
than it was earlier.
You have selected another cleaning program. The Jet
Clean System has three cleaning programs: the eco
program, the normal program and the intensive program.
Each of these programs has a different operating time.
Press the up/down button on the Jet Clean
System to select the cleaning program of your
preference (see chapter ‘Cleaning and
maintenance’).
English
12