Hitachi 55EX9K Manuale Utente

USING THE GENIUS REMOTE TO CONTROL VCR FUNCTIONS 

 

21

• To operate your VCR, point the Genius remote at the remote sensor of 
the VCR. 

The Genius remote is designed to operate different types of VCR's. You 
must first program the Genius remote to match the remote system of your 
VCR. (Refer to Table 1 on page 18). 

(1) Turn ON your VCR. 
(2) Set the Multi-Page select switch on the Genius remote to VCR. 
(3) AIM the Genius remote at the front of your VCR. 
(4) While holding down the SELECT button, press the button that matches 
your VCR as shown on page 18. The channels on the VCR will begin 
changing after 5 seconds when the correct button is pressed. When this 
happens the Genius Remote control is programmed for your VCR. If the 
VCR channels do not change after 5 seconds, try a different Genius 
Remote button. 
(5) Release both buttons when the VCR starts to change channels. The 
precoded VCR buttons will now control your VCR. 

NOTES: 
• If your VCR cannot be operated after performing the above procedures, the 
codes have not been precoded into the Genius remote control and it will not 
be able to operate your VCR. 
• You will only have to program your remote control to match your VCR once. 
The remote will remember the codes until you replace the batteries. 
• Whenever you install or replace batteries in the Genius remote, you must 
reprogram the Genius remote to match the remote system of your VCR. 
• When operating your TV or a cable box, remember to set the Multi-Page 
select switch to the proper position. 
• Refer to the instruction manual for the VCR to operate buttons exclusively 
for the VCR. 
• Be sure to keep the original remote control for the VCR even if you use the 
Hitachi Genius remote to control your VCR.