Microboards Technology gx-1 Manuale Utente
MICROBOARDS TECHNOLOGY, LLC GX-1 DISC PUBLISHER
13
Print Alignment Disc
NOTE: The Alignment Disc should always be printed using Photo mode for the best accuracy.
There are factory default alignment values for the TOP and LEFT values for your GX-1 Disc
Publisher, referring to the top and left margin sizes, respectively. These can be found on the label on
the back of the GX-1 Disc Publisher. You may need to adjust the values, depending on the images
you are printing. To run the alignment utility, first set the Top and Left values are 0 (zero).
Publisher, referring to the top and left margin sizes, respectively. These can be found on the label on
the back of the GX-1 Disc Publisher. You may need to adjust the values, depending on the images
you are printing. To run the alignment utility, first set the Top and Left values are 0 (zero).
1. Place an Alignment CD (see figure 1) in the input bin.
2. In the Utilities menu, select Print Alignment Disc.
3. The alignment guide will be printed on the disc (see figure 2).
4. Confirm the numbers that cross the circle.
5. If the circle does not cross the alignment guide at both zero points, change the vertical and
horizontal numbers in the Utility Tab by the number at which the circle does cross the guide
(See figure 3).
(See figure 3).
6. Once the new numbers are entered, click Apply.
7. The Alignment CD pattern is also included on the GX-1 Disc Publisher CD, so you can print
additional Alignment patterns with your GX-1 Disc Publisher, once it is aligned. The
alignment circle is 8 cm in diameter and is 2 cm from the outer edge of the CD.
alignment circle is 8 cm in diameter and is 2 cm from the outer edge of the CD.
Figure 3
Figure 2
Figure 1