RoyalTek rbt-1000 Manuale Utente

 

6 

 

1.  Before you use the Bluetooth GPS Receiver, the battery must be 

charged. Connect the power charger to the power jack, and then plug 
into an electrical outlet. As the device is charging, the Battery Status 
LED will show a yellow light. 

2.  When the battery is fully charged, the Battery Status LED will turn 

off. Unplug the device and remove the charger. 

1.  The GPS Status LED will initially show a steady green light to show 

that the position has not been fixed yet. 

2.  After the position is fixed, the GPS Status LED will be showing 

flashing green. Now you are ready to connect to your 
Bluetooth-enabled mobile device and use your GPS application. 

1. 

From your Bluetooth-enabled mobile device, perform a Bluetooth 
device discovery. Refer to the user documentation for your 
Bluetooth-enabled device for instructions.

 

2. 

After connection is created between Bluetooth-enabled device and 
Bluetooth GPS, the LED will show flashing blue light.

 

 
             

  Note: If it is needed to type in Pin code during configuration, please Key in 

“ 0000”. 

1.  Load your GPS mapping or routing software,  along  with  the          

corresponding maps of the areas that you are occupying or plan to 
travel to. 

2. 

Start the application. Make sure the application is set for the COM 
port that your Bluetooth-enabled mobile device will use for serial 
communication. Now you should be ready to use your GPS 
application as directed by the user documentation that came with the 
software. More configurations may be necessary. 

3. 

Refer to the following software application user manual to set up the 
parameters of the device via Bluetooth radio.