Outback Power Systems GFX1424E Manuale Utente

 

900-0111-01-00 Rev A 

3

 

Only use components or accessories recommended or sold by OutBack Power 
Technologies or its authorized agents. 

Do not attempt to install this equipment if it appears to be damaged in any way.  See 
the Troubleshooting Section for instructions on how to return the equipment if it is 
damaged or suspected to be damaged. 

  This equipment weighs in excess of 22 kg (49 lbs).  Use safe lifting techniques when 

lifting this equipment as prescribed by local codes. 

  Use standard safety equipment such as safety glasses, ear protection, steel-toed 

safety boots, safety hard hats, etc., as prescribed by local codes when working on 
this equipment. 

  Use standard safety practices when working with electrical equipment (e.g., remove 

all jewelry, use insulated tools, wear cotton clothing, etc.). 

  Never work alone when installing or servicing this equipment.  Have someone 

nearby that can assist if necessary. 

  Review the system configuration to identify all possible sources of energy.  Ensure 

ALL sources of power are disconnected before performing any installation or 
maintenance on this equipment.  Confirm that the terminals are de-energized using 
a validated voltmeter (rated for a minimum 1000 Vac and 1000 Vdc) to verify the 
de-energized condition. 

  Do not perform any servicing other than that specified in the installation 

instructions unless qualified to do so, or have been instructed to do so by OutBack 
Power Technologies Technical Support personnel. 

Internal parts can become hot during operation.  Do not remove the cover during 
operation or touch any internal parts.  Be sure to allow sufficient time for internal parts 
to cool down before attempting to perform any maintenance.   

  Do not place combustible or flammable materials within 3.7 m (12 feet) of 

the equipment. 

  This product contains relays with moving parts and is not ignition-protected. 
  Ensure AC and DC cable sizes conform to local codes.  See pages 19 through 21 for 

minimum size requirements.  Ensure all conductors are in good condition.  Do not 
operate the unit with damaged or substandard cabling.