blue-seal e1100 Manuale Utente

Pagina di 41
-1- 
Revision 4/F3591 
© Moffat Ltd, August 2004 
 
SERVICE MANUAL 
E1100 ELECTRIC 
CONVECTION OVEN 

Sommario delle specifiche per Miele blue-seal e1100

  • Pagina 1 E1100 ELECTRIC CONVECTION OVEN SERVICE MANUAL Revision 4/F3591 -1- © Moffat Ltd, August 2004
  • Pagina 2 WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE CARRIED OUT BY QUALIFIED PERSONS ONLY. Revision 4/F3591 -2- ©...
  • Pagina 3 CONTENTS This manual is designed to take a more in depth look at the E1100 electric convection oven for...
  • Pagina 4Revision 4/F3591 -4- © Moffat Ltd, August 2004
  • Pagina 5: SPECIFICATIONS 1. SPECIFICATIONS MODEL: E1100 1005 50 930 310 75 WATER ENTRY 190 MWS MWS 3 E 3 E 1390...
  • Pagina 6 MODEL: E1100-2 1005 50 930 310 75 WATER ENTRY MWS MWS 730 3 E 3 E 1690 MWS 770...
  • Pagina 7LOCATION The following minimum clearances for air openings, servicing, operation and installation are to be adhered to: Rear 100 mm...
  • Pagina 8: INSTALLATION 2. INSTALLATION WARNING: THIS APPLIANCE MUST BE EARTHED / GROUNDED. WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE...
  • Pagina 9WATER CONNECTION A cold water supply should be fitted to the water inlet which is located at the rear of...
  • Pagina 10: OPERATION 3. OPERATION NOTE: A full user’s operation manual is supplied with the product and can be used for further...
  • Pagina 113.2 EXPLANATION OF CONTROL The temperature control of this oven is with a SYSTEM capillary type thermostat which can be...
  • Pagina 12When the 3 hour timer has run down and reached the Hold position the two switch contacts change over to...
  • Pagina 13: MAINTENANCE 4. MAINTENANCE WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE CARRIED OUT BY QUALIFIED PERSONS ONLY. 4.1 CLEANING...
  • Pagina 14: TROUBLE SHOOTING GUIDE 5. TROUBLE SHOOTING WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE CARRIED OUT BY QUALIFIED PERSONS ONLY. FAULT...
  • Pagina 15 FAULT POSSIBLE CAUSE REMEDY OVEN LIGHT NOT Blown bulb. Replace. ILLUMINATING (Refer service section 6.3.10) Light switch faulty. Replace....
  • Pagina 16 FAULT POSSIBLE CAUSE REMEDY SLOW RECOVERY Oven in ‘Roast ‘n Hold’ mode. Switch off ‘Roast ‘n Hold’. Overloading of...
  • Pagina 17: SERVICE PROCEDURES 6. SERVICE PROCEDURES WARNING: ENSURE POWER SUPPLY IS SWITCHED OFF BEFORE SERVICING. WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK...
  • Pagina 18 6.3.19 Door Ball Catch....................................................................................................28 6.3.20 Door Linkage Chain Assembly ............................................................................28 6.3.21 Door Assembly.....................................................................................................29 6.3.22 Top Bearing Channel ...........................................................................................29 6.4...
  • Pagina 19: No Heat / Elements Not Working (Heating indicator on)6.1 FAULT DIAGNOSIS Fan motor faulty Check the supply voltage across motor termi- 6.1.1 OVEN DOES NOT OPERATE / START...
  • Pagina 20: Slow Recovery6.1.5 OVEN LIGHTS NOT ILLUMINATING 6.1.7 CONTINUOUS WATER OUT OF OVEN WATER NOZZLE Light switch faulty Check voltage to the...
  • Pagina 21: Holding Temperature Incorrectthermostat on and off cycle. The thermostat ‘Roast ‘n Hold’ switch faulty should cycle on and off between 165°C and...
  • Pagina 22: Bottom Lintel6.2 ACCESS 6.2.4 RIGHT HAND SIDE PANEL 6.2.1 CONTROL PANEL 1) Remove the four screws along the top, four screws...
  • Pagina 23: Time Up / Roast Indicators6.2.6 CONTROL PANEL—REAR 6.3 REPLACEMENT 6.3.1 POWER / ROAST SWITCHES 1) Open the control panel (refer 6.2.1). Power Indicator 2)...
  • Pagina 24: 3 Hour Timer3) Press in the locking tabs at top and bottom of the indicator and from rear push 3) Remove the...
  • Pagina 25: Fan Motor 5) Remove the two screws securing the thermostat phial mounting bracket to the RH wall of the oven. Feed...
  • Pagina 26: Water Injection Nozzle3) Pull the fan and motor assembly into the 6.3.13 ELEMENTS oven as pictured below, and disconnect the wiring. The...
  • Pagina 27: Door Microswitch6.3.15 WATER SOLENOID VALVE 6.3.16 WATER SOLENOID CLEANING 1) Ensure water supply is turned off. 1) Remove water solenoid (refer...
  • Pagina 28: Door Linkage Chain Assembly3) Undo the two screws securing the Ball microswitch to the microswitch bracket. catch 4) Replace and reassemble in reverse...
  • Pagina 29: Top Bearing Channel3) Remove the door chain assembly and 6) Undo the two screws securing the bottom replace the broken component. pivot...
  • Pagina 30: Thermostat Calibration6.4 ADJUSTMENT / CALIBRATION 6.4.3 THERMOSTAT CALIBRATION IMPORTANT: IF THE OVEN 6.4.1 DOOR CHAIN TEMPERATURE NEEDS TO BE INCREASED, ENSURE...
  • Pagina 31: Door Microswitch Adjustment Screws 6.4.5 60 MINUTE TIMER ZERO POSITION ADJUSTMENT 1) Remove 60 minute timer knob by pulling it firmly away...
  • Pagina 32: CIRCUIT SCHEMATIC 7. CIRCUIT SCHEMATIC Revision 4/F3591 -32- © Moffat Ltd, August 2004
  • Pagina 33: ELECTRICAL WIRING DIAGRAM 10 MAINS SW. 28 NC 33 POWER 3 NO 4 4 6 5 5 COM DOOR 11 MICRO SW....
  • Pagina 34: SPARE PARTS 9. SPARE PARTS PART NO. NAME ELECTRICAL 013521 Oven Lamp Bulb 003002 Oven Lamp Glass 017960 Fan 010148 Motor...
  • Pagina 35: PARTS DIAGRAMS 10. PARTS DIAGRAMS 10.1 MAIN ASSEMBLY 1 11 10 2 3 9 8 4 5 7 6 Pos Part...
  • Pagina 3610.2 CONTROL PANEL ASSEMBLY Pos Part No. Description 1 011987 THERMOSTAT 50-320 ºC 2 015563 THERMOSTAT KNOB 50-320 ºC 3...
  • Pagina 3710.3 DOOR ASSEMBLY Revision 4/F3591 -37- © Moffat Ltd, August 2004
  • Pagina 38Pos Part No. Description 1 004070 DOOR INNER - L.H 2 004071 DOOR INNER - R.H 3 010627 DOOR OUTER...
  • Pagina 39: SERVICE CONTACTS 11. SERVICE CONTACTS AUSTRALIA VICTORIA - MOFFAT PTY HEAD OFFICE AND MAIN WAREHOUSE 740 Springvale Road Tel (03) 9518...
  • Pagina 40UNITED KINGDOM BLUESEAL LTD Units 6-7 Mount St Tel 0121-327 5575 Business Park Fax 0121-327 9711 Birmingham B7 5QU England...
  • Pagina 41: APPENDIX A. DOUBLE STACKING INSTRUCTIONS APPENDIX A. DOUBLE STACKING INSTRUCTIONS Double Stacking Kit - Part number 016372 Figure A.1 1) Remove the leg tray...
downloadlike
ArtboardArtboardArtboard
Report Bug