Hitachi VM-H620A Manuale Utente

Advanced Techniques 

- 47 - 

hold it. If the remote control code has been set, the VCR channel is counted up automatically. 

Note: Your VCR should have an infrared remote control. 
Note: If the channel on the VCR does not change with the above operation, you need to 
switch the remote control code of your VCR. Refer to the VCR's instruction manual. If the 
channel still does not change after you have changed the VCR's remote control code, the edit 
remote control cannot operate your VCR. 

Hitachi REVERSE 

Sony PROGRAM 

Panasonic FORWARD 

Toshiba IN 

Mitsubishi COPY 

START 

Sanyo OUT 

Sharp 

 

NEC 

 

JVC 

 

Akai A/V 

DUB 

Gold Star 

 

PHILIPS 

 

RCA DISPLAY 

Zenith COUNTER 

RESET 

Magnavox TITLE 

ON/OFF 

Note: The remote control code is held in memory until it is changed or the batteries are 
replaced. 
Note: Point the remote control straight at the VCR's infrared receiver for operation. 
Note: Use the remote control indoors. When the infrared receivers of the VCR and 
camcorder are exposed to direct sunlight or strong artificial light, the remote control may not 
operate correctly. 
Note: The remote control cannot be operated if there is an obstacle between the remote 
control and infrared receiver. Especially, be careful of this during dubbing. 
Note: When the edit remote control is connected to the camcorder, the buttons marked * in 
the figure above perform the same operations as those of the other remote control provided. 

You can select up to four different scenes or segments to be copied at one time. 

Note: If sunlight or strong artificial light strikes the camcorder's infrared receiver, the editing 
operation may not be possible. 

Programmable Edit Hookup 

1. Connect the edit remote control to the camcorder, and then connect the AV stereo output cable 
as illustrated above. 
2. Insert a recorded tape into the camcorder.