Runco cinemawall cw-42hd Manuale Utente

Proper installation of your CinemaWall will ensure the highest possible picture quality. 
Whether you are installing the CinemaWall temporarily or permanently, you should take 
the following into account to ensure that it performs optimally.

To install the CinemaWall, you will need either an optional table stand or wall-mounting kit. 
The CinemaWall cannot be installed on its own. 

If you do decide to wall-mount the CinemaWall, ensure that the wall-mount bracket is 
installed according to the instructions included with it. The wall must be capable of 
supporting a redundant weight factor three (3) times the weight of the display, or be 
reinforced. 

Runco recommends that this be done by a custom installation specialist.

You can attach your optional mounts or stand to the CinemaWall in either of two ways: 

• While it is upright.

 

 

 

 

 

 

 

 

 

 

 

 

 

• As it lies flat with the screen face 

down. Place the protective sheet, 
which was wrapped around the 
plasma monitor when it was 
packaged, between the screen and 
your work surface to avoid 
scratching or otherwise damaging 
the screen surface. 

In general, minimize or eliminate light sources directed at the display. Contrast ratio in your 
images will be noticeably reduced if light directly strikes the display, such as when a shaft 
of light from a window or floodlight falls on the image. Images may then appear washed 
out and less vibrant.

➤

➤